Common Washing Machine Problems and How to Fix Them

🧺 Common Washing Machine Problems & How to Fix Them

🔄 Washing Machine Fills and Drains Water at the Same Time

🚿 Most Common Cause: Syphoning

• Check behind the machine

• The drainage hose may be lying on the ground

• ⬆️ Raise the drainage pipe to the correct height

• This should stop the problem immediately

⚠️ If the Problem Continues

• 💦 The drain pump may be faulty

• Solution: Clean or replace the drainage pump

🚰 Washing Machine Won’t Fill with Water

A washing machine that doesn’t fill with water cannot wash. It may drain and then stop.

✅ Step-by-Step Checks

1. 🚰 Check your water supply – ensure it is turned on

2. 🔩 Inspect the water inlet pipe

3. 🧽 Clean the inlet sieves/filters (often clogged with dirt)

🔧 If Still Not Filling

• 🚨 Faulty water inlet (solenoid) valves

• Our technicians can clean or repair valves before replacement

⚠️ Still Not Working?

• 🧠 The issue may be the control panel board

• This is checked after all other causes are ruled out

⏸️ Washing Machine Stops Mid-Cycle

Several faults can cause the washer to stop during operation:

🚱 Water Shortage

• Follow the water supply checks mentioned above

💦 Drainage Problems

• The machine must drain dirty water before rinsing or spinning

• Check for:

  • 🚿 Blocked drainage pipe

  • ⚙️ Clogged drainage pump

🔄 Motor Issues

• A faulty motor may:

  • Fill water

  • Drain

  • ❌ Fail to rotate the drum

🌡️ Water Level Sensor Fault

• A faulty sensor may send incorrect signals

• Can cause the machine to stop unexpectedly

🧠 Power Control Panel (Last Resort)

• A faulty board won’t communicate with other components

• 🔧 Solution: Control panel replacement

🌊 Washing Machine Overfills with Water / Flooding

⚠️ This is dangerous – act immediately

🚨 First Safety Steps

• 🔌 Switch off power immediately

• Turn off electricity to prevent:

  • Electric shock

  • Damage to control panel, motor, sensors, valves

🔍 Diagnose the Cause

• If the machine fills even when powered off:

  • 🚰 Solenoid inlet valves are faulty

  • These must be replaced

💧 Remove Excess Water

• Use the emergency drain hose

• Or place the drain pipe flat on the floor

• Use syphoning to empty the drum

⚙️ Key Components to Check

• 🚰 Solenoid inlet valves (main cause of overfilling)

• 🌡️ Water level sensor (controls filling level)

• 🧠 Control panel (if problem persists)

🔄 Washing Machine Won’t Spin

Before calling a technician, check the following:

💦 Drainage First

• The washer only spins when the drum is empty

• Ensure:

  • Drain pipe is clear

  • Drain pump is not blocked

⚙️ Check the Spin Belt

• Open the back panel

• 🔧 Ensure the belt is intact and properly fitted

• Refit if loose

🔌 Motor & Control Check

• If the belt is fine but the drum won’t spin:

  • ⚠️ Motor or control board may be faulty

  • 📞 Call a technician for diagnosis

📞 Need Professional Help?

We offer same-day washing machine repair services.

📱 Call us now: 0790076362
Fast • Reliable • Expert Technicians Near You